RS Component’s DesignSpark Mechanical v4 could have come at a better time as I my fledgling knowledge of 3D printing had just extended to realising my cheap 2nd hand printer need a bit more cooling to make the printing filament set quicker – known as ‘part cooling’. The cooling duct on the right does not ...
This story continues at 3D printing an fan nozzle, and ‘blend’ in DesignSpark Mechanical
Or just read more coverage at Electronics Weekly
from Electronics Weekly https://www.electronicsweekly.com/blogs/engineer-in-wonderland/3d-printing-fan-nozzle-blend-designspark-mechanical-2018-12/
No comments:
Post a Comment