Having done quite a bit of 3D printing with my trusty tiny cheap Fabrikator v2, a few issues are emerging. DIY diameter-reducing sleeve installed One is z-wobble (visible here) caused by a rigid yet slightly non-coaxial coupler between that and z-axis drive stepper motor, and a slightly bent leadscrew. My obscure printer uses the same leadscrew ...
This story continues at Two days before the lathe
Or just read more coverage at Electronics Weekly
from Electronics Weekly https://www.electronicsweekly.com/blogs/engineer-in-wonderland/two-days-lathe-2019-01/
No comments:
Post a Comment